Home :: Tools :: Bumper Parking Sensor Punch

Bumper Parking Sensor Punch

•For re-fitting parking sensors after accident damage

•Hole cutter sizes: 17, 18, 18.2, 19, 20, 22.5, 24, 26, 26.7, 32mm

•Cuts up to 5mm plastic •Includes 5/16" HSS Drill Bit

https://www.youtube.com/watch?v=sY0unzYHNs4


The operation couldn’t be easier; drill the pilot hole in the new panel (5/16" HSS drill bit included), then choose the correct combination of die and cutter punch from the set (ten hole sizes available). Assemble with the die behind the panel and the cutter punch on the outer face then tighten the nut on the force screw with a 12mm socket and within seconds the hole is cut, leaving a clean finished edge on the outer surface of the panel.

Up to 5 mm plastic can be cut and the following hole sizes are accommodated in the set: 32, 26.7, 26, 24, 22.5, 20, 19, 18.2, 18, and 17mm

DO NOT USE AIR TOOLS OR YOU WILL STRIP THE THREAD.

14%
SKU CT747
Weight 3.50 kg
 
Market price: $220.00
Our price: $190.00
(Ex GST)
Qty
Add to wish list
: *
: *
: *
Type the characters you see in the picture:


*
The code is case-sensitive and must be entered exactly as above.
 
 
Malco Nano Care Banana Creme Wax - 946ml
 
Transtar Autobody Technologies Finish-Tec 1 Quart Gray Primer
 
Nextorch C4 Rechargable Compact Flashlight
$79.00
 
$160.00
 
$109.00
 
 
 
Pascal File Blade Half Round 9TPI
 
Mothers Wash Brush – Short Handle
 
Rupes New 150MM Multihole Hookon M8 Hard Pad
$65.00
 
$18.00
 
$135.00
 
 
 
Rediwipe Alcohol Wipes 75 Wipes
 
Bristle Blaster® Cordless Set SB-701-BMC
 
Autoglym Hyperfresh 3 Pack
$20.00
 
$2200.00
 
$70.00